For TM L96.

Included these parts.
Palsonite Cylinder / Taper Cylinder Head / Spring Guide / Hard Piston
*If you use this cylinder, thicker diameter ver. spring is necessary. Please see here...

Palsonite Cylinder : Toughnes & beauty Cylinder

Internal diameter 20 mm,
Made of SUS304. Inner diameter torelance ±1/100mm. Processed laser welding & fixed by parallel pins.




Using this cylinder,the piston will get more speed & you'll get stable output.
We processed the Palsonite to precision cylinder to be less friction between a piston & cylinder. So you'll get more smooth action & that gives stable & high power performance.

We adapt new technology of 01 & 05 inner barrels called "cold hammering"
This cylinder is same accuracy as Inner barrel. The inner diameter tolerance is 1/100mm In spite of cylinder.
We have never seen as this accuracy tolerance of this cylinder.
PDI adopted seamless pipe that has accuracy equal with inner barrel made by other companies,
and stainless steel that was adopted by PDI is made in Japan by cold hammering.

The welded points
Combine body & End Boss.

※The tolerance described by our company refers to the "straight" part which is not machined. The slotted part is not related to the airtight performance so its tolerance is not design to be as tight as other places.

Taper Cylinder Head

Made of SUS303. The nozzle's length is for TM L96.
Its tapered line is the best suited angle for airflow.

Hard Piston

The body & The head: Made of Duralmin.
The Ring: Made of Derlin.
The End: Made of Carbon Steel.
We use most suitable materials for each parts, so this piston has high durability.

If use this piston to extreme power spring as PDI SS,SPR & over 2J setting,it'll be shorter life.It's up to your operation & maintenance.

Hard Piston can make more velocity than Vacuum Piston because of its hight airtight.
* VC Piston needs a little longer time to airproof than HD Piston.It is the difference (Velocity) between them.

Spring Guide

Spring Guide
Made of Stainless steel and Polished,so it makes smooth action.
It has a thrust ring that made of derlin.

When you set PDI precision cylinder for TM L96, you should take care of these points.

1.L96-59(cylinder support ring / from the TM L96 manual)
Because precision cylinder is bigger than original one, when you set precision clinder, you should remove the support rings.
As a result, there is a possibility that the surface of the cylinder is damaged.
If you do not want to damage the surface of the cylinder, you should polish the inside diameter of the support ring with the file.

2.L96-58(barrel base inner / from the TM L96 manual)
We recommend you to polish inside of barrel base, because it made by zinc die-cast, and the inside surface is not smooth.

When you customize it, there is a possibility that you can not cock.
Please note the following points when solving it by using pure parts.
1.Angle of setpin and SP guide.
2.Attrition of piston end
3.Attrition of cylinder inside.
There is a possibility of solving it when these are corrected.